UTD1000L User Manual
17
1. Set the attenuation coefficient of probe
multiplying power as 10
firstly
set the switch
on probe as 10
and connect probe with input
channel of oscilloscope
Connect probe pointer
with output port of the compensation signal
generator.
2. Set automatically
3. Observe the displayed waveform
f the displayed waveform on the screen show
under compensation
or
over compensation
as the above picture, use the adjust pen with non-
metal handle of the probe auxiliary to adjust
variable capacitance of the probe until
correct
compensation
were shown on the screen as the
above picture
to guard against the electric shock in
measuring the high voltage with the probe, please
make sure that the insulated conductor of probe
is intact and do not touch the metal part of the
probe when connecting with the high voltage
source
Press key V
mV to adjust vertical gear v div
of oscilloscope
and to adjust signal to appear
on the screen with the proper size
When the channel symbol is solid, press up/down
keys to adjust ground baseline position to adjust
signal to appear on the screen with the proper
size
,
，
.
;
.
“
” “
”
“
”
.
.
～
( /
)
,
；
；
I
Warning:
Vertical System
Munual Set Vertical System, Horizontal
System and Trigger Level
Over compensation correct compensation under compensation
