MS2007 Owner’s Manual - Page 3
4. Press remote Button 4 to save the time setting.
• The remote will play a tune to confirm the time is set.
System Status Check
To check the current status of your system, press Button 4 on the remote for 2 seconds. The LCD
will display
followed by the current status of the system. The vehicle must be within
range for this feature to operate.
Disabling the Remote Confirmation Tunes
To disable the remote confirmation tunes:
1. Press and hold remote Button 4 until
is displayed.
• The remote will beep three times.
2. Release Button 4.
• The remote will show
and
.
• The remote will provide a beep confirmation when buttons are pressed, but the tunes
will be disabled.
Battery Replacement
Your Ungo Remote Transceiver uses a standard AAA battery, which will need to be replaced from
time to time. Under normal conditions, the battery should last for up to three months before it
needs replacement. When your remote’s battery is in need of replacement, the battery symbol on
the LCD display panel will flash. To change the battery, slide down the battery cover on the back
of the remote and insert the new battery. Make sure the positive and negative terminals are
positioned correctly and replace the cover.
Adding a New Transceiver into the System
Have the desired remotes ready (up to 2) and follow the steps below:
1. Turn the ignition on, off, on, off, on within 4 seconds.
• The siren will chirp once.
2. Press and hold the Valet switch for 2-3 seconds.
• The siren will chirp 3 times.
3. Press Button 1 on each remote.
4. Turn off the ignition.
Any transceivers that were previously learned to this system and not included in this procedure
will no longer operate this system.
Additional Remote Transceivers
Additional Remote Transceivers for your MS2007 are available from your Authorized Ungo dealer.
Summary of Contents for MS2007
Page 1: ......
