5
1.2 WHEN STARTING SYSTEM:
• For use only with tap water.
• Do not connect to pressure washer or auxiliary pump.
• Do not exceed water pressure of 115 psi.
• Check system for cracks/damage.
• Be sure cover is in fully locked position.
1.4 INTENDED USE:
This product is designed for personal use only. Always ensure that the product
is properly assembled, regularly maintained and used only as intended.
This product is meant to be used outside and stored at a temperature between
40°F - 100°F. Use this device only for water treatment to reach an optimal water
quality for spot-free cleaning.
Any other use, especially water treatment for
food production (e.g., beverages) or drinking water consumption is prohibited.
Prior to product assembly and start-up, it is essential that you observe the safety
information and instructions for installation and maintenance contained in this
manual. Unger is not liable for damage to application areas, plumbing system
components or persons. Unger is not liable for misuse or mishandling of the
product, including dropping, dragging or dismantling.
As with any equipment, care must be taken when operating and servicing the unit.
There is a risk of damage to the system due to:
• Operating and installation errors.
• Use of loose resin (overfill and expansion of resin will damage unit).
• Vessel is opened incorrectly.
• Using non-Unger spare parts.
• Performing unauthorized modification to unit.
• Insufficient maintenance.
1.1 GENERAL WARNINGS:
• Never direct water towards eyes or face.
•
KEEP OUT OF REACH OF CHILDREN AND PETS.
Do not allow product to be
used as a toy. Close supervision is necessary when any appliance is used by or
near children.
• To prevent electrical shock, do not use near any sources of electricity, including
electric and power lines.
• Do not use on electrical equipment or appliances.
• After unpacking the product, be sure to carefully dispose of any plastic bags to
avoid injury.
• Use only as described in this manual.
• Use only manufacturer’s recommended attachments.
• Be sure cover is in locked position prior to use.
• Do not exert excessive pressure on release mechanism as breakage may occur.
• Drain the water from the unit after each use.
• Do not allow unit or resin to freeze.
• Ensure work area has sufficient water drainage.
• Turn off water supply when not in use.
• Do not drink water produced by this product.
1.3 BEFORE OPENING SYSTEM TO REPLACE RESIN:
1. Shut off tap water supply.
• Spilled resin is a slipping hazard. Clean up spilled resin immediately.
• Wash hands thoroughly after use.
• Resin can cause eye irritation. Avoid eye contact. In case of eye contact, immediately flush
eyes thoroughly with clean water. Consult doctor if symptoms persist.
3. Turn ON/OFF valve to “OFF” position.
2.
Press yellow FastLock™ lever on
system head assembly.
4.
Disconnect outlet hose.
Bottom
Top
