16
7.0 STORAGE
1.
Shut off tap water supply and disconnect hoses from both ends of the unit.
2.
Drain water from the unit by tilting the top of the unit forward and allowing
water to drain from the bottom of the tank, via the input connection.
3.
Replace plug on both the inlet and outlet connection to prevent the resin
from drying.
The system should be stored in a dry place at a temperature between
40°F - 100°F. Do not allow product to freeze or damage might occur.
Storing the product in an upright position is recommended.
If storing the
product for longer than 6 months without using, remove the resin and discard
it in accordance with applicable federal and local laws and regulations .
Also remove batteries from TDS Meter.
• Do not store resin in open or unlabeled containers.
• Store resin in a cool (40°F - 100°F), dry place.
CARE MUST BE TAKEN WHEN OPERATING AND SERVICING THIS PRODUCT.
THERE IS A RISK OF DAMAGE TO THE SYSTEM DUE TO:
• Operating and installation errors.
• Use of resin filter other than that specifically made for Unger Professional
Rinse 'N' Go Max™ system.
• Use of loose resin (loose resin will most likely cause clogging and reduce flow rate).
• Pressure is not released correctly.
• Performing unauthorized modification to product.
• Improper maintenance and storage: Never store below freezing. Always seal unit
(inlet and outlet) between uses using plugs to prevent resin from drying out.
• The outer packing material can be recycled. Please recycle.
• Please dispose of used resin filter in accordance with applicable
federal, state/provincial and local laws and regulations.
8.0 ENVIRONMENTAL INFORMATION
