EYE XO2 INSTALLATION GUIDE
9
3.1
Hardware Install - Continued
Step 1: Mount Bracket
The EYE XO2 Sensor and bracket come attached together in the box. Slightly loosen
the black M6 15 mm screws that are holding the sensor to the bracket so you can
remove it. Please make sure you have measured 3.5 feet from the front and middle
of the sensor to your tee position. Do NOT align to the bracket.
Place the ladder under the location on the ceiling where the bracket will be
mounted. Place the bracket flat against the ceiling with the hinges facing down
toward the ground. The longer side of the hinges must be closet towards the
impact screen.
With the bracket in position, grab the 10 silver M4 32mm screws and screw them in
the locations below in the diagram.
M9 32mm (5)
M9 32mm (5)
1
3
2
H
ard
w
are
