UNDATEC Flow Measurement Solutions
Frank Stark - Wiesenstrasse 23 - D-75248 Oelbronn-Duerrn / Germany - T49 (0) 7237-7804
Email: [email protected]
5. FDL400 Programming
After switching on the device is displayed on the display device identification , hardware version, software
version, and copyright.
Example:
FDL400
H – Version 2.0
S – Version 2.3
copyright UNDATEC
After a few seconds the display will jump to the measurement menu.
The display shows velocity, level, flow and totalizer.
Example:
Velocity 0.00 m/s
Level 0.000 m
Flow 0000.0 l/s
Total 000000 x 1 m3
Function buttons
Button „B” = Break (Interrupting the measuring program for inputting parameters)
Button „E“ = Enter
Button „F“ = Correction
Button „A“ = Abbort
Button „C“ = no function
Button „D“ = special function
Functions
(Button „B“ generated entry into the function menu. Here, the desired function will be
selected by entering the corresponding function number)
The functions are designed so that they are self-explanatory based on previous selection.
Function 1:
Entering of channel shape and associated parameters. It can be a pre-programmed
channel shape
(Circle, rectangle, trapezoid, triangle or special) are selected.
If special channel shapes are available, they are read in via memory card (SD card).
Function 2:
Enter the maximum values for V, H and Q.
(Maximum values refer to the 0/4 - 20mA current outputs. Maximum value is the value at
which for the selected output the current of 20mA has the full scale).
Function 3:
Entering the limit values for V, H and Q.
(Limits refer to the switch outputs 1,2 and 3. Switch output 4 is for a different
Application allocates.
Value is the value at which the selected switching output switches).
