DuraMax
ENGLISH
21
Recalibration
1.
To recalibrate the device, you need an additional remote control or an
additional SensoCommander (except SensoCommander Classic). Position
one SensoCommander at the height of reference point A2 (see the two
previous pages). Then perform calibration with the other.
2.
During calibration, pay attention to the alignment of the DuraMax and
the displays for the X and Y axes (E, I). Always calibrate both axes. You
can switch between axes with button 14 of the additional remote control
or SensoCommander.
3. Set the device to calibration mode:
Switch off the DuraMax, and then, with the auto/man button (J) depres-
sed, switch on again (briefly press ON/OFF button (G). Keep the auto/man
button (J) depressed until the tilt display (C) lights up. When this happens,
the auto/man button (J) can be released.
4. Correcting calibration:
Using button 15 of the additional remote control or SensoCommander,
move the laser from its present position to the height of reference point
A2.
5. Ending calibration:
Cancel: By switching off the DuraMax, the entire calibration is rejected
and the previous status restored.
Save:
The new calibration can be saved by pressing button 17 of the
additional remote control or SensoCommander.
X
Y
X- / Y- axis
Note:
Regularly check the calibration
before use, after transport and after
extended periods of storage. Always
make sure to control all axes. See
also "General safety information" on
page 13.
