－
6
－
3. OPERATION
3.1 Check
The oil mist trap has been shipped after rigorous inspection at the factory,
but check upon the following unpacking it.
(1)
Is the unit the correct model you ordered?
(2)
Are accessories (instruction manual, parts you ordered) supplied with the
unit?
(3)
Is any part damaged or missing and any screw or nut loosened in transit?
If you find any problem, contact your local ULVAC organization or
representative.
3.2 Mounting on Pump (Refer to Fig. 4)
To mount the oil mist trap on the pump, proceed as follows.
(1)
Verify that the exhaust port, O-ring groove and oil mist trap (TM) flange
are free from scars and dust.
(2)
Mount the O-ring (V55) to the exhaust port of the pump and tighten the TM
flange using an Allen screw (M8).
3.3 Duct Piping
The exhaust port of the oil mist trap has a cap as standard, but has a flange
(RF-11) for duct piping as option. Use it depending on your application.
CAUTION :
① The flange for the duct piping (RF-11) is equivalent to VG4O.
