Ulvac GN-30i, Instruction Manual

Page: 12 / 30

6 ULVAC CRYOGENICS INCORPORATED
1.3 Specifications
Table 1-1 Shows the specifications of GN-30i.
Table 1-1 GN-30i Specifications
Items Specifications
Model GN-30i
Purity (*1) 99 vol%
N2 production rate (*2) 30 NL/min
Discharge pressure 0.2 MPa
Dewpoint Below -60 °C
Flow meter (*3) 50.0 NL/min
Electrical rating
Voltage and frequency
Main power source 200VAC (single-phase) 50/60Hz
Power consumption 1200W
Operating method Input operation signals
Input and output
electrical signals
Input
Remote signal: CLOSE while in operation
Contact capacity:DC30V 20mA required
Output
Running signal: In operation (ON)
N2 supply signal: While supplying (ON)
Alarm signal: While in alarm state (ON)
Relay contact output: Continuous load current 100VAC
below 1A
Drained water
processing
Evaporation inside the equipment
Nitrogen gas exit
φ
6 easy coupling
Ambient
temperature(*4)
5 - 40
°C
Ambient humidity(*4) 10 - 80%RH
Dimensions 600(W) x 650(D) x 1,300(H) (excluding casters)
Weight Approx. 120Kg
Color DIC 546 1/2
Compressor 2688CS32-273 (made by Thomas) x 3
Noise level 60dB(A)
When measured from front 1m and height 1m
*1
Purity of N
2
(nitrogen) + Ar(argon).
*2 This is the volume measured at the ambient conditions of temperature 20°C and
humidity 60% RH and converted to 0°C and atmospheric pressure. The production
volume above is the maximum generation rate under the conditions of temperature 20°C
and humidity 60% RH and filters are cleared. The production rate decreases when
depending on the conditions such as temperature or humidity.
*3 Flow meter is made to fit the above discharge pressure. If it is used at the pressure
other than the above, conversion is needed.
*4 This is not to guarantee the performance under these conditions.