If using for the first time:
Unpack the Bubble Master and inspect all components. Although the
packaging was designed for the rigors of today’s parcel delivery services,
damage may have occurred during shipping.
1. Prior to operation, the extension sleeve may be placed into the bubble
outlet. This will allow the bubbles to be projected higher, before they
begin to disperse outwards.
TECH TIP
: For lower flying bubbles do not use the extension sleeve.
2. Place the Bubble Master on a level sturdy surface, or use the optional
adjustable stand sold separately.
3. Open a container of Ultratec Bubble Fluid, and pierce the foil top. Pour
the fluid into the bubble outlet. Fill up to 1/2” below the reservoir top.
This initially should take approximately 1 gallon.
NOTE:
Care must be taken when filling with bubble fluid to ensure that fluid does not overfill above the
dividing “dam” and enter into the rear of the machine. Drain holes are manufactured into rear
compartment in case of accidental spillage.
4. Plug the Bubble Master into an outlet that is capable of sustaining the
current load listed on the product serial plate.
Operation of the Bubble Master has been engineered to be simple and intuitive.
Use the Fan Speed Control knob to start the bubble wheel and fans,
and to control the fan speed.
By varying the fan speed you can control
the bubble volume, size and height.
Fan Speed Control
High
Low
Off
Fan speed contol
Location
Bubble Master Operation
Set Up Procedure
4
www.ultratecfx.com
