UltraSonic LLC. Model Ultra 2400FA
4
•
Do Not Plug in Machine until unit is full of water and cleaning solution, doing so
may cause damage to your UltraSonic tank and Void warranty
Flip rocker switch
POWER ON/up
button,
Heater Control
&
Ultrasonic
lights will
display green.
Operating temperature is pre-set @ 150°F on the
TEMP CONTROL
. Initial heat-up
time using cold water is approximately two hours. For automatic heating see
Programmer – Heat
When operating temperature of 150°F is reached, set
Ultrasonic Timer
to 15 minutes
and push green
Cycle start
button. This process, known as degassing, will remove air
from the bath, which is required for effective cleaning. During this degassing phase
some squeaking sounds may occur, this is normal.
Unit is now ready to clean parts, see NORMAL OPERATION procedures.
Fill out WARRANTY REGISTRATION form, page 15 (serial # plate located on
back panel of unit) and send back to UltraSonic LLC to ensure activation of your
warranty.
