Installation
LOCATION
Mount the UltraPure
™
Automatic Water Cleaner
™
indoor or outdoor (preferably out of direct sunlight).
Select a wall location within 8 feet of the 120V or 240V timer box or the 120V grounded plug, and
within 15 feet of the suction side injection point and 7 feet with above ground units.
Note: The UltraPure
™
Automatic Water Cleaner
™
is to be installed on the suction side of the pump,
as it will not withstand pressure.
WALL MOUNTING
It is recommended that your UltraPure
™
Automatic Water Cleaner
™
is mounted horizontally to
improve lamp life. Use the slots in the mounting tabs, the screws and wall plugs provided to secure
the unit. The above ground units come complete with mounting pad brackets which bolt to the unit
tabs.
ELECTRICAL
A qualified electrician should perform the electrical procedure(s).
Connect the UltraPure
™
Automatic Water Cleaner
™
to the pool timing clock so that the UltraPure
operates simultaneously with the pool pump or plug your 120V unit into a grounded receptacle.
Above ground units come complete with a 120V Piggy back cord. The circuit must be protected by
a ground fault circuit interrupter (G.F.C.I.) installed in accordance to electrical code.
Operating your UltraPure
™
Automatic Water Cleaner
™
on a single speed pump 6 to 12 hours per
day will clean the pool water and extend lamp life. When using a 2 speed pump, the ozone gener-
ator is operating only on high speed, typically 2 to 4 hours per day. Typically, the above ground units
run for 24 hours a day.
Be sure to check the voltage of the power supply is matched to the voltage of your unit.
Shut off the pump before plumbing your UltraPure
™
Automatic Water Cleaner
™
.
Proceed to plumbing instructions.
3
Pool
Owner’s Manual and Installation Instructions
UltraPureManual12pg34072.indd 5
UltraPureManual12pg34072.indd 5
24.03.16 15:09
24.03.16 15:09
