UltraPlus X-9200HD PVR, User Manual

Page: 49 / 86

49
3.1 Dish Setting

Select the satellite/antenna and LNB settings for
service search. The values that are set in this menu
will be available for selection in other service
searching menus.

Satellite :
Select the satellite which you want to do a search
for.
- Press the
LEFT/RIGHT ARROW button to select
the satellite.
- If you press the
OK button, the entire satellite list will be displayed.
- Select the desired satellite name to search.
- If the desired satellite name is not listed then select User Defined.

Tuner Connection : You can set connection type, Separate or Loop-Through.
NOTE : Tuner Connection menu is disabled if receiver is not configured with twin satellite
tuners.
- Separate : Set the connection type option to
‘Separate’
, if each of the tuners are connected to
different LNBs (TUNER 1 / TUNER 2) individually / independently, or when the tuners are connected
through a multiswitch. Due to the independent & separate connections between the two Tuners &
LNBs, the user can watch all the services scanned by one
TUNER 1
, while the other
TUNER 2
is
recording.
- Loop-Through : Set the connection type option to
‘Loop-Through’
, if you have connected the LNB
OUT (TUNER 1) and LNB IN (TUNER 2) with a loop-through cable. In this case, you would have some
limitations in using some features such as dual recording.
This configuration allows both tuners to use a single LNB or a number of LNBs connected with a
22KHz or DiSEqC switch. However, this will limit the possible tuning range (Satellite & Polarization)
of the 2nd tuner, while the 1st tuner is recording because the input signal of 2nd tuner is dependent
of the signal which the 1st tuner is using.
NOTE : User should make the appropriate connection by choosing the right tuner connections.
Misconfiguration of these settings may cause the loss of signal reception. We strongly
recommend you seek professional advice if your knowledge is limited.

Tuner : Select the tuner which you want to set (Tuner 1/ Tuner 2). If you set
‘Loop-Through’
on the
menu
(Installation-Dish Setting-Tuner Connection),
this menu(Tuner) will be disabled automatically.

Frequency : Select the satellite frequency which you want to use to check the signal.

LNB Power : Select the LNB power on or off.

LNB Type : Select the LNB type.

LNB Frequency : Select the local oscillator (L.O.). frequency that is specified for the LNB used.
- Use the LEFT/RIGHT ARROW buttons to select the LNB frequency.
- If the required LNB frequency is not listed, then enter the frequency manually using the NUMERIC
buttons.
- When you select Universal LNB type, both 9750 and 10600 are supported at the same time. And
then the LNB 22KHz setting is disabled (as this is used for L.O. switching).

LNB 22KHz : : If you use a separate 22KHz tone switch box, enable the 22KHz tone if you are
connecting to the 22KHz side of the switch, and disable it if you are connection to the 0KHz side of the
switch.

DiSEqC Switch : If you use DiSEqC 1.0 or DiSEqC 1.1 switch, select one of the DiSEqC inputs.