1. Micro USB port
2. Power jack
3. Power switch
4. SPI port
5. Serial number
User Guide
1
3
2
4
5
1
2
3
4
Transformer
Array
Leap Motion
®
camera module
Thank you for purchasing an Ultrahaptics TOUCH Development Kit (UHDK5). This user guide provides an
introduction to the contents in the box, how to get started and how to access support (if required).
1. Remove the security tape from the top and
bottom boards.
2. Connect the Leap Motion
®
camera module to the
computer using the Leap Motion
®
camera module
cable.
3. Connect the control board to the computer using
the Micro USB 2.0 cable.
4. Connect the power supply to the control board
power connector.
5. Connect the power supply to the mains power
source once all the other connectors have been
inserted (steps 1-3). Set the power switch to
on
.
Note: The TOUCH Development Kit (UHDK5) has been pre-loaded
with the required firmware.
•
User guide
•
Development Kit hardware platform (192-transducer
square array board, control board, frame structure
and Leap Motion
®
camera module)
•
Leap Motion
®
camera module cable
•
Micro USB 2.0 cable
•
Multi-regional (US, UK and EU) power supply
•
'Compliance, Health & Safety and Warranty' booklet
UHDK5-00000001
B01-00001-00
V3.5 EX1 4916
