PUMP FOR HYDRAULIC SYSTEMS
-
page 17
of 71
Installation and maintenance manual
ULTRAFLEX
E
N
G
L
ISH
MAIN STEERING STATION
ADDITIONAL STEERING STATION
MAIN STEERING STATION
ADDITIONAL STEERING STATION
3 Connect pipes as shown in picture following the manual instructions.
At the end of the installation make sure that the pipes do not interfere
with the engine and with fixed or mobile parts of the boat or of the
steering system itself.
WARNING
The minimum bending radius of the pipes is 250 mm. Any excessive
pipe bending could break them by compromising the good operation
of the system. If necessary, replace the damaged pipe.
WARNING
Keep clean. Make sure that working areas are free from dust and dirt.
The protective plugs of threaded holes must be removed only before
the connection of fittings and pipes. Make sure that pipes are perfectly
clean and free from swarf. If copper or steel pipes are used, cleaning
is mandatory. If the installer uses pipes that are different from Kit OB,
he must take full responsibility for it.
WARNING
WARNING
Keep the pipes far from heat sources and from chemical substances.
Protect the pipes that must pass through bulkheads by using suitable
thru hulls. The bends must be perfectly smooth; any bent pipe or
dent would prevent the hydraulic oil passage.
NO
Minim
um
radi
us 250
mm
1
1
2
2
Kit OB
cylinder
connecting
pipe
Kit OB-2S
Kit OB
cylinder
connecting
pipe
Kit OB
cylinder
connecting
pipe
Kit OB-2S
