Installation manual
page 16
of 27 -
ZTF TILLER SYSTEM
This check requires careful attention.
This operation requires careful attention.
8
Bring the two ultrabolts into contact with
the engine tiller arm and fasten them using a
9/16" wrench with a torque of 54 Nm (40 lb.-
ft.).
CAUTION
9
Afterwards, while holding a screw with
a 9/16" wrench, fasten the corresponding nut
with a torque of 54 Nm (40 lb.-ft.). Repeat this
operation on the other nut always by holding
its screw.
Double-check the tightening of screws and
nuts by repeating the same procedure
described in points 8 and 9 (fastening screws
and nuts while holding screws).
CAUTION
10
Complete the assembly of UC130 cylinder on the outboard engine following what is reported on
the installation and maintenance manual of the cylinder itself, except for the fastening phase of the
cylinder link arm to the engine arm, which is described in the previous points.
Do not disconnect the hydraulic hoses for any reason.
11
Assemble Yamaha
®
tiller handle on the ZTF device as described in paragraph 3.5.
NOTICE
