Installation and Maintenance Manual
ULTRAFLEX
E
N
G
L
ISH
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
-
page 11
of 83
Allen wrench
[1/8”]
Open end
wrench
3/4"
Open end
wrench
9/16"
Torque wrench
MOLYKOTE
®
1000
Open end
wrench
16mm
3 INSTALLATION
3.1 Minimum transom requirements
The following picture shows the minimum splash well dimensions. These dimensions must be respected in
order to prevent the cylinder from being damaged when the outboard engine is completely tilted upwards.
The picture shows also the minimum transom dimensions, needed for the installation and the correct
operation of the engine steering cylinder.
ENGINE JACK PLATE APPLICATION TO THE TRANSOM.
A jack plate installation will change all the application clearances. A new clearance check must be completed
with the tilting of the engine in conjunction with the vertical movement of the jack plate in all the possible
positions. If the steering cylinder comes into contact with the splash well, transom and/or jack plate,
stop
the installation immediately!
Use the jack plate manufacturer's instructions to limit the upper or lower
direction in which the interference occurs. If this is not possible please contact specialized staff.
WARNING
Engine No.
A
B
C
1
560 mm - 21.25"
152 mm - 5.98"
152 mm - 5.98"
2
1110 mm - 43.70"
152 mm - 5.98"
152 mm - 5.98"
MINIMUM SPLASH WELL DIMENSION REQUIREMENTS
3.2 Necessary tools
C
B
A
³
90°
