![background image](http://html1.mh-extra.com/html/ultraflex/easy-melt-air-1g/easy-melt-air-1g_operation-manual_3461278006.webp)
UPT Series Easy Melt
Operation Manual
Version 1.2 6
www.ultraflexpower.com
1.2.2
UNPACKING AND INSPECTION
This equipment has been thoroughly inspected and tested prior to packing and is ready for operation. After careful
unpacking, visually inspect for shipping damage
BEFORE
attempting to operate. If any indication of damage is found,
file an immediate claim with the responsible transport service and advise your sales representative.
INSPECT EQUIPMENT BEFORE INSTALLING. DAMAGED EQUIPMENT MAY RESULT IN IMPROPER
OPERATION AND CREATE A HAZARDOUS CONDITION RESULTING IN PERSONAL INJURY OR
DEATH.
THE CARRIER IS RESPONSIBLE FOR ALL DAMAGE CAUSED IN SHIPMENT INCLUDING CONCEALED
DAMAGE.
1.2.3
SELECTING THE DEVICE SITE
Consider the following when choosing a location for the device:
•
Make sure the system is installed in a debris free zone;
•
The device has to be connected to a power source;
•
Make sure the device is easily accessible by the operator;
•
Device has to be seated on a mechanically secure surface;
1.2.4
COOLING REQUIREMENTS
The power transistors and rectifiers in the Power Supply are maintained within their safe operating temperature
range by means of forced air cooling (fans). The fan inlets must be kept clean from obstructions in order to insure
proper air circulation. If installed in confined spaces, care must be taken that the ambient temperature (the
temperature of the space immediately surrounding the Power Supply, does not rise above the limit specified as 40°C.
Periodic cleaning of the Power Supply exterior is recommended.
1.2.5
AC INPUT CONNECTION
The Power supply connects to the power network through a 6 ft (1.80m), power cord (supplied). Additional fuse or
circuit breaker and residual current circuit breaker on that power branch is a good choice since it will provide extra
protection in addition to the unit’s internal protection. A mechanical switch is also recommended within the
operator‘s range and vision and possibly closer to the Power Supply.
Only trained personnel should open the unit cover and operate the breakers.