Installation and maintenance manual
ULTRAFLEX
E
N
G
LI
S
H
page 14
of 15
B505
5 MAINTENANCE
5.1 Ordinary maintenance
Failure to apply maintenance controls may result in loss of control when driving, which can result in damage
to property and/or injury.
Maintenance requirements will vary depending on climate and frequency and type of use. Inspections must
be conducted at least every two years by an experienced marine technician.
Perform the following maintenance operations:
- Periodically wash components with fresh water and remove any salt deposits.
- Once a month, check all nuts holding the system in place and tighten if necessary.
Loosening or separation of nuts holding the system in place can cause not only malfunctioning of the control
but damage or injury.
- Periodically check that there is no corrosion on metal parts of the cable terminals or abrasion on the
sheath.
- Replace damaged parts that may compromise the integrity of the control.
5.2 Special maintenance
Technical assistance
For any information or assistance with particular applications, you are invited to contact our technical
assistance service (refer to “Note”).
IMPORTANT
DANGER
