Installation and maintenance manual
ULTRAFLEX
page 8
of 47 -
SINGLE LEVER CONTROL B301 AND B302
E
N
G
L
ISH
3 INSTALLATION
3.1 Tools required
Phillips
screwdriver
Pliers
Open end
wrench
8mm [0,31”]
Socket wrench
17mm [0,66”]
1
Remove the rubber
cover from the lever
hub (1).
3.3 Adjustment of the lever inclination
The lever angular position can be adjusted both forward and backward according to the control position.
Follow the instructions below:
1
2
Extract the plastic
pin (2).
4
Extract the lever
and turn it to the
desired position, then
reinsert it by putting
into gear with the
shaft of the control
box.
2
3
Take
out
the
hexagonal head screw
(3) with a 17 socket
wrench.
3
3.2 Control box installation
1
Install the control in a position that allows the lever to rotate free and take care that it can reach the
full forward and full reverse stroke.
2
Refer to the overall dimensions given in paragraph 1.2 to check that the box can effectively be
installed in the desired position.
3
After determining the appropriate location, drill the holes required to assemble the control box
using the template provided for single or dual control.
When the cable is installed avoid too narrow bends.
WARNING
NOTICE
For the single and dual control installation refer to the drilling templates enclosed.
Connect the cables to the lever before the lever control to the dashboard.
CAUTION
The use of a proper killing switch system is recommended for each ULTRAFLEX control system installation.
