ULTRACOM AVIUS, Manual

Page: 11 / 60

11
Bluetooth mode of the Avius host device is not
successful, try to change the Bluetooth mode by
holding down the connection button for 6 seconds
(the button that is located under the power button
of the host device). After the host device blinks the
green LED light, release the button and wait for the
host device to change its Bluetooth mode.
After the host device has changed the Bluetooth
mode, the blue LED light will blink twice per second
until the connection to the phone is successful.
When the connection has been established to the
mobile device, the blue LED light will blink once per
three seconds.
Note that after changing the Bluetooth mode,
the AviusLINK has to be reset from the Ultracom
application’s settings menu and the Bluetooth
pairing has to be established again. This is done
by opening the main menu, selecting “Settings”,
opening the additional menu from the upper right
corner and selecting “Reset AviusLINK”.
4.5 Attaching the collar to the dog
When the devices are ready for use, you can attach
the collar around the dog’s neck. Tighten the collar
around the dog’s neck to a suitable tightness and
close the buckle carefully. Put the collar around the
dog’s neck in such a way that the collar’s battery
compartment is below the dog’s neck. The position
of the GPS compartment with the LED lights varies
depending on the circumference of the dog’s neck.
It is a good idea to wait until the satellites have
been found before placing the collar around the
dog’s neck. It is recommended that you wait until
you have one location before releasing the dog so
you can check that the battery has enough charge
and that the collar and host device are working
flawlessly.
4.6 Turning off the devices
Turn off the collar by placing the magnet icon on the
back of the host device (Figure E) against the power
icon on the collar (Figure F). Hold the host device
against the collar until the LED lights on the collar
go out.
The host device can be turned off by holding down
the power button on the host device (Figure D) for
three seconds. The LED light on the host device will
illuminate for three seconds, after which the LED
lights on the host device will go out.
5. Other functions
5.1 Pairing additional collars with the host device
One host device can receive location data from
several Avius collars (max. 50 collars). The collars can
be added in the Ultracom application by opening
the main menu, selecting “Add Device…”, selecting
“Avius” from the menu, inputting ID, name and
password, and selecting “Save”. The device appears
on your devices list.
5.2 Updating the devices
The firmware on the Avius host device and the
Avius collar can be updated using the Ultracom
application.
Start the Avius host device and collar. The firmware
update is done in the Ultracom application’s info
menu.
Please see the latest update instructions on our
website in the Avius support area.
5.3 Indication of a connection between the
mobile device and the host device
When a Bluetooth connection has been established
between the mobile device and the host device,
the blue LED light on the host device will blink once
every three seconds.
If the Bluetooth connection to the mobile device
breaks off, the blue LED light on the host device will
blink once a second. The Ultracom application will
also report that the connection has disconnected.
Follow the instructions provided by the Ultracom
application to re-establish the connection.
5.4 Indication of a connection between
the collar and the host device
The green LED light on the host device will blink to
indicate that data is being received from the collar
selected in the application.
If you have not selected an Avius collar in the
Ultracom application, a blinking LED light indicates
the presence of other Avius collars in the range of
the host device.
EN