Page 4 of 8
INSTALL THE LIGHTBAR
Magnetic mounting
1. The magnetic lightbar should be positioned on the vehicle
’s roof where the magnets will
safely secure the lightbar. Before mount the lightbar to the roof, be sure the surface is
clean and clear of dirt, grease and debris.
2. Locate the desired location where you wish to mount the lightbar. For best results you
should make sure the lens is unobstructed, so that the light can be seen 360 degrees.
3. If you need to move the lightbar, hold one side securely, then lift the other side of the
lightbar from the room and move; repeat procedure to move the other side.
Permanent mounting
1. Upside down the lamp, take off the rubber boots. Remove the M6x20 screw (6), which in
the center of magnetic bases. The magnetic base (5), sleeve gasket (4), spring (3) pulled
away from the light body (1). (See Figure 1)
2. Drill a mounting hole for M6x45 Hex bolt (10) on the mounting surface. Insert M6x45 Hex
bolt (10) to the spring washer (9), flat washer (8), mounting surface, rubber gasket (7),
and mounting hole of lightbar. Then tighten the M6 bolts. (See Figure 2)
Summary of Contents for 40511
Page 7: ...Page 7 of 8 ...
