- 4 -
II.
INSTALLATION AND OVERVIEW
A.
Installing Ultrapol Advance
i.
Mechanical
The main hardware is shipped as two items; the Base Unit and the Mast Head assembly.
The Base Unit should be placed on a flat, sturdy bench.
The Mast Head assembly may then be installed on the Base Unit, by use of the ‘base lock lever’
positioned at the rear bottom of the head assembly. The protruding nut and bolt should be inserted into
the wide radius section of the ‘keyhole’ on the top right rear of the base. The head may then be slid to
its ‘zero’ position (the position where Mast head assembly cannot go further forward towards the front
and is parallel with the base plate). At this point the base lock lever may be turned to lock the head
into position.
ii.
Coolant
Coolant is an important part of the polishing process. The Solenoid Water Actuation system is
generally used. Feed your water source into the back of the polisher, using the supplied nose piece and
switch the Coolant Switch to the on position on the front panel. Water will begin to pump onto the
polishing surface. Adjust the water pressure with the valve on the side of the faucet.
iii.
Drain
The Base needs to be placed for convenient drainage. The drain exits from the rear panel through a
fitting onto which the supplied drain hose is pressed. This drain can be fed into a container (a gallon
plastic container is usually convenient). Alternatively, the feed may be directed into the facility drain,
if faucets are used.
