14 Pin Power Connector
Step 2- Plug-In The Module
Step 3- Program, Test And Adjust The Shock Sensor
Test The System
When all the connections are done, the control module can be plugged in. Before connecting the
control module, make sure the ignition is in the
OFF
position. Plug in the 6 pin harness then the 14
pin followed by any other connectors that were used.
Black
Ground Input
System ground input.
Yellow
Ignition Input
Input from vehicles ignition wire.
Red
MainPower Input
Positive output for siren.
White
(+) Park lights
Programmable - menu 2, setting 3.
Green*
(-) Door Input
Negative door pin switch input.
Purple*
(+) Door Input
Positive door pin switch input.
*Test for door pin type (Positive or Negative) then connect the appropriate wire (Green or Purple)
To program the Shock Sensor.
1.Press and release
Lock
button
Five
times.
2.The system will chirp and the park lights will flash
three
times then stay
“ON”
.
3.Within 10 seconds impact vehicle in a safe place (i.e. - Window pillar) with amount of force
wanted to activate alarm. The siren will chirp upon learning the impact.
4. The Shock Sensor is now programmed.
5. Press the
Unlock
button to exit the Program Mode.
To test the Shock Sensor.
1. Press the
Lock
button once to arm the system.
2. Wait five seconds then impact the vehicle. Lighter impacts to the vehicle should trigger the warn
away (The siren will chirp three times). A harder impact to the vehicle will trigger the full
alarm.(The siren will activate for 60 seconds then turn off).
3. To deactivate the alarm when triggered, press the
unlock button twice.
To adjust the Shock Sensor.
1. Repeat the shock sensor learning.
- If the sensor was to sensitive, impact the vehicle with greater force.
- If the sensor was not sensitive enough, impact the vehicle with less force.
*For best results ensure that the Control Module is mounted securely to the vehicle.
1. Open all the vehicles windows.
2. Press the Lock button to arm the system.
3. Wait five seconds (or until the dome light goes out) then reach in through a window and open
the door.
The alarm will then activate (repeat on all the doors).
4. Test the Shock Sensor again and adjust if necessary.
5. Insure that all additional features are working as intended.
6. If necessary proceed to Program Mode to adjust the programmable outputs.
Quick Start Install
Step 1 - Connect All Of the Following Wires
Your Basic Install Is Complete!
PAGE 6
SECURITY SYSTEM
INSTALL GUIDE
