PAGE 12
OWNER'S MANUAL
LCD FUNCTIONS
ARM
PM
12:15
PAGER
1
F
PROGRAM
TRANSMITTER LEARNING
The system can lean up to 4 different remote transmitter codes. Each remote to be used MUST
be programmed together during the same sequence. For security, when a new remote is
programmed all previous remotes that are not reprogrammed at this time will be deleted.
1- Cycle the ignition key ON-OFF-ON-OFF-ON.
2- Press and hold the Button on the antenna, the park lights will turn on and the siren/horn
(optional) will chirp/honk once. (Continue Holding antenna Button).
3- After 5 seconds the park lights will turn off and the siren/horn will chirp/honk 5 times to
indicate you have entered Transmitter Learning Mode.
4- Press the Lock Button on each of the transmitters to be programmed. The park lights will flash
and siren/horn will chirp/honk once to indicate successfully learning of each transmitter.
5- Turn the ignition key OFF to exit remote Program mode.
DUAL CAR OPERATION (CAR-1 / CAR-2)
2 WAY REMOTE ONLY
The 2way remote transmitter can be programmed to a second vehicle to
control the alarm and remote starter feature. By default the remote is set to
CAR-1, this is indicated by number 1 on the LCD screen. In CAR-1 the LCD
back light is Green, in CAR-2 mode the back light is red.
The second vehicle must also have the same model 2way starter installed. To
Program the remote in second car mode,
1- Press and hold the # Button until the Program icon appears.
2- Press and release the Lock Button until the number 1 icon turns on.
3- Press the Start Button to change form 1 to 2.
4- Press # to exit.
Now that the remote is set for CAR-2 “2". You can Program it along with the other remote to the
second vehicle. The remote now controls the second vehicle’s functions. To go back to CAR-1
operation follow the steps above. Press the Unlock Button instead of Start Button to change
back to CAR-1 “1".
U500/U550
PAGE 13
OWNER'S MANUAL
LCD FUNCTIONS
Enter Clock Adjustment Mode,
1- Press and Hold the Lock and # Buttons for 3-5 seconds.
2- The remote will play the Program tune.
3- The PROGRAM icon will turn on and the minute portion of the clock will
start to flash.
Clock Adjustment
The clock must be set when the remote battery is removed or replaced. Follow the steps
below to set or adjust the clock.
ARM
PM
12:45
PAGER
1
F
Setting the Minutes
1- Press and release the Unlock Button to decrease the Minutes.
2- Press and release the Start Button to increase the Minutes.
3- To Select the Hour press and release the Lock Button.
3- To exit press and release the # Button.
ARM
PM
12:15
PAGER
1
F
PROGRAM
PROGRAM
Setting the Hour
1- Press and release the Unlock Button to decrease the Hour.
2- Press and release the Start Button to increase the Hour.
3- To Select the Minutes press and release the Lock Button.
3- To exit press and release the # Button.
ARM
PM
1:15
PAGER
1
F
PROGRAM
Exit Clock Adjustment Mode
1- Press and release the # Button.
2- The remote will exit Clock Adjustment Mode.
3- The PROGRAM icon will turn off.
*If no Buttons are pressed for 15 seconds the remote will automatically exit
Clock Adjustment Mode.
ARM
PM
1:15
PAGER
1
F
U500/U550
