Page 9
REMOTE VEHICLE STARTER/ALARM
INSTALLATION MANUAL
6 Pin Power Connector
Step 1 - Connect All Of the Following Wires
Yellow
30amp Starter Output
12volts during start position only.
Green
30amp Heater Output
12volts in the accessory position off during
start and 12volts during run.
Red
30amp Power Input
Constant 12volt power at ignition harness
or from battery.
Red
30amp Power Input
Constant 12volt power at ignition harness
or from battery.
Blue
30amp Ignition Output
12volts in the ignition, start and when run
positions.
White*
30amp Select Output
Selectable Output for vehicles that require
2nd Ign, Acc or Starter wires.
*Note:
The white wire may not be required on all vehicles.
14 Pin Connector
Step 2- Plug-In The Module
Black
System Ground Input Connect to Chassis Ground.
White
Park Light Output
Connect to (+) Park Light system.
Green/Wht
Hood Pin Input
Connect to the Hood Pin Safety Switch.
Blue/Wht
Tach
Connect To A/C Tach Source.
Pink
Brake Switch
Connect To (+) When Brakes Is Applied.
Wht/Blue
Siren
Connect to Siren Positive Activation.
Green*
(-) Door Pin Input
Connect to door pin (-) when doors opened
Purple*
(+) Door Pin Input
Connect to door pin (+) when doors opened
* Connect only one of the door pin inputs. If the vehicle has a positive door pin
system connect the purple wire, if negative connect the green wire.
Manual Transmission Connections (”M” Models Only)
Black/Wht
Park Brake Input
Connect to Park Brake wire.
Never install an automatic module into a manual transmission vehicle!
When all the connections are done, the control module can be plugged in. Before
connecting the control module, make sure the ignition is in the
OFF
position. Plug
in the 6 pin harness and the Auxiliary harness, then any other connectors that were
used. The park lights will flash and the siren will chirp 2 times to confirm power
up on automatic transmission models. Manual transmission models will flash the
park lights and chirp the siren 4 times to confirm power up.
