Page 19
Menu 3- Starter Settings
Ignition
ON-OFF-ON-OFF-ON
Press & Release
Program Button
Press
Button #3
Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm)
.
1) Type 1
1 Flash/chirp
Unlock before start. Lock pulse after start and on shutdown.
2) Type 2
2 Flashes/chirps
Lock pulse ONLY after remote start shutdown.
*3) Type 3
3 Flashes/chirps
Default Lock/ Unlock Pulses.
Press & Release the Program Button 1 Time
(Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button
to proceed to the next step.
Setting 2 14pin Connector- Gas/Diesel Mode (Blue wire on 14-pin)
1) (-) Input
1 Flash/chirp
(-) Glow Plug input. Waits maximum 30 seconds then starts.
2) Time Delay
2 Flashes/chirps
Waits for approximately 15 seconds then remote starts.
*3) Gas/ (+) Input
3 Flashes/chirps
Waits 2 seconds to start if no diesel input is detected.
Press & Release the Program Button 2 Times (Setting 2)
Confirmed with 2 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button
to proceed to the next step.
Setting 3 Rearm Output (Yellow wire on 14-pin)
1) Type 1
1 Flash/chirp
Pulse after start and with lock. (Provides Lock Pulse)
2) Type 2
2 Flashes/chirps
Pulse after start only. (Provides Lock Pulse)
*3) Factory Re-arm 3 Flashes/chirps
Pulse with lock and after starter shutdown.
Press & Release the Program Button
3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button
to proceed to the next step.
Setting 4 Run Time
1) 4 Minutes
1 Flash/chirp
Runs for approximately 4 minutes when activated.
2) 45 Minutes
2 Flashes/chirps
Runs for approximately 45 minutes when activated.
*3) 15 Minutes
3 Flashes/chirps
Runs for approximately 15 minutes when activated.
Press & Release the Program
Button 4 Times (Setting 4) Confirmed with 4 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button
to proceed to the next step.
Setting 5 Maximum Crank Time
1) 10 Seconds
1 Flash/chirp
10 sec max time that the starter will stay engaged.
2) 3 Seconds
2 Flashes/chirps
3 sec max time that the starter will stay engaged.
*3) 5 Seconds
3 Flashes/chirps
5 sec max time that the starter will stay engaged.
Press & Release the Program Button
5 Times (Setting 5) Confirmed with 5 LED flashes.
Press & Hold the Program Button
until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button
to proceed to the next step.
REMOTE VEHICLE STARTER/ALARM
INSTALLATION MANUAL
