Setting 5- Run Time
1 30 Min Run Time 1 Flash Remote Starter runs for 30min when activated
2 45 Min Run Time 2 Flashes Remote Starter runs for 45min when activated
3* 15 Min Run Time 3 Flashes Remote Starter runs for 15 min when activated
Setting 6-Maximum Crank Time
1 10 Seconds 1 Flash 10 sec Max time that starter will stay engaged
2 3 Seconds 2 Flashes 3 sec Max time that starter will stay engaged
3*5 seconds 3 Flashes 5 sec Max time that starter will stay engaged
Press the Program Button 5 times
to select setting 5 (This will be confirmed by 5 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Press the Program Button 6 times
to select setting 6 (This will be confirmed by 6 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Setting 7- Tach Selection
1Tach Detection 1 Flash Set for Tach Detection - Must Connect Tach Wire
*2Tachless Mode 2 Flashes No Tach connection required
Press the Program Button 7 times
to select setting 7 (This will be confirmed by 7 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Setting 8- Adjust For Over-Crank
1 - Enter Program Mode
(Ignition ON-OFF-ON-OFF-ON) then press the Program Button.
2 - Press the Program Button -
8 times
(Led will start flashing 8 times).
3 - Hold the Program Button -
For 5 seconds until parking lights flash (each time lights
flash tach is reduced).
4 - Release the Button - Exit Program Mode and remote start to test.
Setting 9- Adjust For Under-Crank
1 - Enter Program Mode
(Ignition ON-OFF-ON-OFF-ON) then press the Program Button.
2 - Press the Program Button -
9 times
(Led will start flashing 9 times).
3 - Press and Hold Program -
For 5 seconds until parking lights flash (each time lights
flash tach is increased ).
4 - Release Program - Exit Program Mode then remote start to test.
