Yellow Starter Output
Connect To The Vehicles Starter Wire.
Green Heater Output
Connect To The Vehicles Accessory Wire.
Red 12 power Input
Connect to Constant 12 Volt Power Source
-
High Current.
Red 12 power Input
Connect to Constant 12 Volt Power Source
-
High Current.
Blue Ignition 1 Output
Connect To the Vehicles Primary Ignition.
White Selectable Output
Select Jumper Position (If Necessary)
. See Page 5.
6 Pin Power Connector
14 Pin Power Connector
Your Basic Install Is Complete!
Step 1 - Connect All Of the Following Wires
Black
System Ground Connect To Chassis Ground.
Pink
Brake Switch Connect To (+) When The Brake Pedal Is Applied.
White
Park Lights Connect To (+) Park Light System.
Green/White
Hood Pin Connect To Hood Pin Switch.
(Must Be Connected)
Blue/White Tach
Connect To A/C Tach Souse
(Tach Mode Only)
Green* (-) Start
Connect to Negative start activation input.
Purple * (+) Start
Connect to Positive start activation input.
* Connect only one start input. The start input will require 3 negative pulses within 2 seconds to
activate the remote starter.
** The start input can be connected to such things as factory keyless entry (Connect to unlock
wire) or an auxiliary output from a aftermarket alarm system.
TACH LEARNING
1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (The Park Lights will turn on).
3) Start the vehicle with the key, the program LED will come when proper tach signal is detected.
After 30 seconds the park lights will turn off then flash twice to confirm Tach learning.
*
The system will flash the park lights seven times if not Tach/ Tachless learned and the start button
is pressed. The system must be Tach/ Tachless learned before remote starting.
**
If the program LED does not come on during tach learn, a proper Tach signal was not detected.
Note: If the park lights do not flash in Auto Tach Learn Mode it may be necessary to connect
to a different tach source. For best results connect the tach to the coil pack or to a fuel
injector wire.
TACHLESS LEARNING (TL Models Only)
1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (The Park Lights will turn on).
3) Start the vehicle with the key, the program LED will turn on after 30 seconds then the park lights
will turn off and flash twice to confirm Tachless learning.
Note: If the first ignition wire is connected to a wire that does not stay 12 volts in the start
position the system will not Tach/ Tachless learn.
***The system must be reset to re-Tach/Tachless learn.
Step 2- Auto Tach/ Tachless Learning (TL Models)
QUICK START INSTALL
