![background image](http://html1.mh-extra.com/html/ultra-start/1155-series/1155-series_install-manual_3419532007.webp)
Programming Menu
.
Turn the ignition key to the on position 3 times then press and release the program
button. The park lights will turn on and the horn(Optional) will honk once. While the
park lights are on press and release the program button until the LED is flashing the
same number of times as the program setting that is to be changed. Press and hold
the program switch until the park lights flash the correct number of times as the
option to be programmed.
Setting 1- Start Trigger Input- Number of pulses to activate Remote Starter
1 Three Pulses 1 Flash Three pulses required to activate the remote starter.
2 Two Pulses 2 Flashes Two pulses required to activate the remote starter.
3 One Pulses 3 Flashes One pulse required to activate the remote starter.
Press the Program Button 1 time
to select setting 1 (This will be confirmed by 1 LED flash)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Press the Program Button 2 times
to select setting 2 (This will be confirmed by 2 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Press the Program Button 3 times
to select setting 3 (This will be confirmed by 3 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Press the Program Button 4 times
to select setting 4 (This will be confirmed by 4 LED flashes)
Press and hold the Program
Button
until you receive the appropriate # of park light flashes and/or horn honks.
Release the Program Button
momentarily to move to next program step or repeat to change selection
Continued on next page...
Setting 2- Special Door Lock/ Unlock Operations
1 Type 1 1 Flash Unlock before start. Lock pulse after start and shutdown
2 Type 2 2 Flashes Lock pulse only after remote starter shuts off
3* Normal Operation 3 Flashes No additional re-lock pulses
Setting 3- Gas/ Diesel Mode- Blue Wire on 14-Pin
1 (-) Glow Plug 1 Flash Waits a maximum 30 seconds before starting.
2 15 Seconds Delay 2 Flashes Ignition ON for 15 seconds before remote starting
3* Gas/ + Glow Plug 3 Flashes Waits 2 seconds to start if no diesel input is detected
.
Setting 4- Rearm Output- Yellow Wire on 14-Pin
1 Type 1 1 Flash Pulse after start and with lock
2 Type 2 2 Flashes Pulse after start only
3* Factory Re-arm 3 Flashes 0.75 second pulse with lock and after shutdown