background image

SYSTEM PROGRAMMING - 

Menu 1

PAGE 14

INSTALL  MANUAL

ANTI CARJACK MODE

ACTIVATING ANTI CARJACK MODE (International Model Only)

Type-1

 - The timer will start if the door is opened or if the # button is held for 3 seconds while 

the ignition is on.

Type-2

 - The timer will start if the door is opened or if the # button is held for 3 seconds while 

the ignition is on. The timer will also start every time the ignition is turned on.

When programmed, the Anti Carjack timer is triggered when a door is opened or a button is 
pressed on the remote while the ignition is on. Type 2 Carjack Mode will trigger the timer with 
the door and trunk button as well as each time the ignition is turned on.

If Anti Carjack is triggered, there will be no indication in the first 20 seconds.

After 20 seconds the LED will begin to flash rapidly to indicate that the Carjack feature is 
active. After an additional 20 seconds the siren will then start to chirp each second for an 
additional 20 seconds. 

The alarm will now activate, the ignition will interrupt, parking lights will flash, and the siren will 
alert indicating trouble. The lights and siren will pause momentarily between each one minute 
cycle, and repeat until disarmed.

Note - Turn the ignition key off before opening the door to avoid triggering the Anti Carjack 
Feature. Pressing and releasing the valet button with the key on during the first 60 seconds will 
stop the Carjack timer.

To disarm the Anti Carjack timer process during the initial 60 seconds of activation, turn the 
ignition key off then on, then press the valet button momentarily.

To disarm the Anti Carjack alert process during the lights and siren cycles, turn the car off then 
on, then press and hold the valet button for 5 seconds.

This feature requires that the user must be fully aware of the operation of this feature. If the 
system goes into full alarm the remote will no longer function until the Anti Carjack Feature is 
disabled.

ANTI CARJACK FEATURE

ANTI CAR JACK ALERT

DISARMING ANTI CARJACK FEATURE

U500/U550

SYSTEM PROGRAMMING - 

Menu 1

PAGE 15

INSTALL MANUAL

DIAGNOSTICS

U500/U550

 ALARM STATUS / DIAGNOSTICS

 OVERLOAD DIAGNOSTICS

SIREN CHIRPS

LED FLASHES

DIAGNOSTICS / STATUS

3

2

SHOCK SENSOR TRIGGER

3

3

DOOR / HOOD TRIGGER

3

4

IGNITION TRIGGER

0

OFF

SYSTEM DISARMED

0

ON SOLID

SYSTEM IN VALET / SERVICE MODE

0

SINGLE FLASHES

SYSTEM ARMED

0

RAPID FLASHES

PASSIVE ARM COUNTDOWN

If the alarm system is triggered, the system will retain in memory the cause of the 
trigger.  When disarming the alarm, the siren/horn will chirp 3 times to indicate the 
alarm had been triggered. The system’s LED will also flash in pulses to indicate 
which input triggered the alarm.

*LED status will be cleared when the ignition is turned ON. For proper memory 
clearing, insure to connect the alarm ignition input to the ignition on the vehicle.

If an output from the alarm is shorted the siren

 

will

 

chirp

 

4

 

times

 

and

the

 

park

 

lights

 

will

 

flash

 

4

 

times when the system is armed or disarmed. The LED

 

will

 

flash a 

diagnostic code that represents the circuit that is at fault. (See Chart Below). Turning 
the ignition to the on then off position will reset the diagnostic code.

LED FLASHES

OUTPUT DIAGNOSTICS

2

LOCK OUTPUT OVERLOAD

3

UNLOCK OUTPUT OVERLOAD

4

TRUNK OUTPUT OVERLOAD

5

STARTER DISABLE OVERLOAD

6

AUX 3 OUTPUT OVERLOAD

7

AUX 2 OUTPUT OVERLOAD

8

2ND UNLOCK OUTPUT OVERLOAD

Summary of Contents for Ultra Start 500 Series

















Reviews: