6 GB/IE/CY
Introduction / Safety
Introduction
Car battery charger ULG 3.8 A1
Q
Introduction
Please carefully read these operating
instructions and fold out the page with
the illustrations. Keep these operating
instructions in a safe place and hand them over to
anyone to whom you pass on the appliance.
Q
Proper Use
The UlTIMATE SPEED UlG 3.8 A1 is a battery
charger with a pulse trickle charge mode and is
suitable for charging and maintenance charging of
the following 6 V or 12 V lead rechargeable batter-
ies with wet cell or gel electrolyte:
• 6 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 1.2 Ah to 14 Ah
• 12 V: with a capacity of 14 Ah to 120 Ah
You can also used it to regenerate completely dis-
charged batteries. The battery charger has protective
circuits to prevent sparking and overheating. Any in-
correct or improper use leads to loss of the warranty.
The manufacturer takes no responsibility for damage(s)
arising out of usage that is contrary to the instructions
laid down. The appliance is not meant for commer-
cial use.
Q
Delivery Contents
Check the appliance and all accessories for damage
immediately after unpacking. Do not put a defective
appliance or parts into operation.
1 Charger
UlTIMATE SPEED UlG 3.8 A1
2 Quick / contact clamps (1 red, 1 black)
1 Operating manual
Q
Component description
see Fig. A:
1
lED display (standby)
2
„6 V“ lED display „Mode 1“
3
lED display „Mode 2“
4
lED display „Mode 3“
5
lED display „Mode 4“
6
lED display „incorrect polarity / fault“
7
lED display „fully charged“
8
lED display „Charging process active“
9
Q
Selection button „MODE“
The following pictograms are used in these operating instructions / on the device:
Read instruction manual!
V~
Volt (AC)
Observe caution and safety notes!
Safety class II
Caution – electric shock!
Danger to life!
For indoor use only!
Risk of explosion!
Keep children away from
electrical devices!
Risk of fire!
Check that the device, mains lead
and plug are in good condition!
W
Watts (Effective power)
