7
GB
rubber hammer can help with this). Fasten with
the spring washers
2
and screws
3
supplied
(see Fig. A).
2) Insert the down rod section (without plug)
4
into the linking piece
1
(see Fig. B). Take the
plate
8
and pull the pin
9
which is
underneath the plate
8
in an outwards
direction (see Fig. C). Place the plate
8
, as
seen in fig. D, onto the down rod section
(without plug)
4
and let it glide through the
rod to the lowest hole on the rod
4
. Push the
pin
9
through the existing hole and allow the
plate
8
to slide down (see Fig. D). The
position of the plate is now secured.
3) Load the rim with tire (see Fig. E). Proceed in
same sequence for the next tire (see Fig. F).
4) Now, put in place the end rod section (with
plug)
5
(see Fig. G). Proceed as described
above, until all 4 tires are properly stored (see
Fig. H).
5) If you would like to make use the storage
container
7
for storing assembly items,
carefully remove the stopper from the end rod
section
5
(e.g. with the aid of a screwdriver).
Place the storage container
7
on the end rod
section
5
.
notes:
the two individual parts of the storage
container
7
must be joined with the
corresponding screws
10
before being used.
For this, please use a crosshead screwdriver,
size PH1.
Instructions for use
of accessories
The tyre chips
14
are placed on the valves as a
simple means of labelling when storing tyres.
The air pressure gauge
12
is used for taking rough
measurements. If needed, go to the nearest petrol
station to check the pressure more accurately.
use:
push in the measuring rod of the air pressure
gauge
12
fully before use. Then place on valve
and read off pressure in desired units on the
measuring rod. If the pressure is too high, the valve
can be pressed in using the button on the side of
the gauge to let out air. The tread gauge
11
is
used for taking rough measurements. Go to a
garage if necessary. The required profile
measurements may vary by country. Therefore
please find out about the specific regulations in
your country.
The storage container
7
is for the storage of
assembly accessories.
Maintenance and care
The tyre stand and the central linking piece
1
should be checked regularly for damage or
wear.
Use a damp cloth for cleaning. Do not use any
cleaning fluids, solvents or sharp objects.
Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
Summary of Contents for 94600
Page 4: ...4 C D E 8 9 8 9 4 4...
Page 5: ...5 F H G 4 5 4 5...
