7
UAS P-Series Service Manual 574-848-2200
Adding a New FOB
NOTE: A valid FOB paired to the system has to be used to start the programming
sequence in order for the system to recognize the additional FOB.
NOTE: Each FOB has to be added individually.
1. Stop the vehicle and turn off the engine.
2.
Using a FOB paired to the vehicle, press the button once to prompt the READY mode
(BLINKING flash) on the programming switch. READY mode will last for
(3)
seconds before
timing out.
3. Press and hold the programming switch for (
5)
seconds to enter the LEARN mode. The switch
will FLICKER flash to indicate that it is in LEARN mode.
4.
Press and release the button on the unpaired FOB. The programming switch will STEADY ON
flash then DOUBLE flash to indicate the FOB is paired and immediately exit the LEARN mode.
5. Now the original FOB and the added FOB are programmed to the vehicle.
6. Test the new FOB to verify door operation.
7. Repeat the steps to add another FOB.
Erasing FOBs
Quick Erase
This section explains how to delete (deny access to) all FOBs that have been programed to a single
vehicle. If a FOB is lost or stolen, this process will disable its access.
NOTE: A valid FOB paired to the system has to be used to start the programming
sequence. The paired FOB used to start this sequence will be the only one programmed
to the vehicle when completed.
1. Stop the vehicle and turn off the engine.
2. Using a FOB paired to the vehicle, press and release the button once to prompt the READY
mode (BLINKING flash). It will stay in READY mode for only
(3)
seconds before timing out.
3. Press and hold the programming switch for (
20)
seconds to enter ERASE (BLINKING flash).
The programming switch will STEADY flash and FLICKER flash before exiting the ERASE
mode automatically. The vehicle will now only recognize the FOB used to enter the READY
mode and delete access to all other paired FOBs.
4. FOBs can now be paired to the system using the
Adding a New FOB
process.
NOTE: If the lost FOB was programmed to multiple vehicles, each vehicle will need be
reprogrammed separately.
