15
Install the hardware accessories
Placing and connecting the NFC spool holder
1. Gently place the printer on its right side.
2. Insert the spool holder into the back panel. First place the top part in the hole and push down until it snaps into place.
3. Connect the NFC cable to the NFC socket. The flat side of the connector faces away from the bottom panel.
4. Guide the NFC cable through the slot in the back panel.
5. Insert the cable cover into the back panel to keep the cable in place.
6. Gently place the Ultimaker upright.
Placing the glass plate
1. Open the two build plate clamps at the front of the build plate.
2. Gently slide the glass plate onto the build plate and ensure that it snaps into the build plate clamps at the back.
3. Close the two build plate clamps at the front to secure the glass plate.
