14
[Figure 2] - Turn gas control to “OFF”.
[Figure 3] - Connect supplied regulator
and do not over-tighten.
SETUP INSTRUCTIONS
REGULATOR CONNECTIONS:
Your Ukiah Co gas fire pit is equipped with a specialized pressure
regulator, which is a device to control and maintain uniform gas
pressure as gas is released from the LP cylinder. This pressure
regulator is designed for vapor withdrawal.
WARNING
: Use only the original specially designed regulator
supplied with your unit. Using another regulator may be dangerous.
WARNING:
Use tanks that are marked “Propane Fuel” only.
WARNING
: Read carefully all instructions contained on the
information plate attached to the fire pit.
WARNING
: Do not transport your fire pit with LP Tank connected.
1. Place the fire pit in the desired location. Make sure that it is placed
outdoors in a well-ventilated area away from any flammable structures,
awnings, vegetation, etc.
2. Place your 20lb LP tank in a location that is not in a walkway or
where it can be easily knocked over. Maintain 60 inches between the
unit and tank. For safest operation use a commonly-available LP tank
holder.
3. Make sure the unit gas control knob is turned to “OFF” by pushing
it in and turning it clockwise to the off position. [Figure 2]
4. Make sure the propane cylinder valve is turned off by turning valve
clockwise.
5. While holding carrying handle closest to propane cylinder, connect
regulator to propane cylinder and turn clockwise until snug (DO NOT
OVER-TIGHTEN). Use only supplied regulator included with your unit.
[Figure 3]
WARNING:
Do not over-tighten or use a wrench to tighten the
regulator connection. Over-tightening could damage the regulator
coupling and cause a leak.
LP TANK REMOVAL:
When the LP tank needs to be replaced, follow these instructions to
remove it.
1. Make sure gas control knob is turned “OFF” by pushing it in and
turning it clockwise to the off position.
2. While holding carrying handle closest to propane cylinder with one
hand, unscrew propane cylinder from regulator.
