ujk technology 506300, Original Instructions Manual

Page: 14 / 28

UJK Dovetail Jig Processes
14
Screw together the guide bush and fixing ring, fix this
to the base of the router, with the flange section facing
downwards out of the bottom of the router, this will run
on the template. It is important that the cutter is totally
central within the located guide bush, if unsure check
with a centralising cone (not supplied), see fig 11-12-13-
14.
0.1
Fig 11-12-13-14
Dovetail cutter
Fixing ring
Guide bush adaptor
Cutter shank
Collet
Visual mark
Flange facing down
Setting the Cutter Height
12. With the router still unplugged, carefully position the
router on the jig. Locate the guide bush within the fingers
of the comb, then adjust the cutter height so that the tip
of the cutter is level with the scribe line as marked with
the cutting gauge (see step 3). When this has been set,
lock off the height setting and carefully remove router
from the jig, see fig 15.
0.1
Fig 15
13. Set up the extraction mounting/support bar on the
jig and connect this to a vacuum extractor, see fig 16-17.
0.1
Fig 16-17
Extraction assembly
Extraction hose
14. Plug the router in to the power supply, carefully
position the router on to the jig. Remember that the
cutter is now set and protruding out of the base of the
Cutting the Tail Boards
3/4” guide bush