0
0
0
0
0
0
0
0
0
0
0
0
4
Assembly Instructions
Find the two large nylon washers (R) and slot them over the
two Phillips screw threads (P)
Locate the nylon sled fence (F), insert the first oval nut (G) into one of the machined ‘T’ slots in the nylon fence (F) and slide the
fence on. Repeat the procedure for the remaining oval nuts until the nylon fence is in line with base plate (C) sides.
Put to hand the five Phillips screw with oval nut (G). Remove
the oval nuts, slot the screws through the countersink holes in
the base plate (C) and reattach the oval nuts, see illustration
above.
Repeat the procedure for the two large washers (S)
Locate the two top plate clamping knobs (M) and screw them
onto the Phillips screw threads (P)
Move the ‘T’ bar (a) so the countersink
holes (b) are not obstructed
G
G
F
F
A
R
S
M
P
C
2
6
10
3
7
11
4
8
12
1
5
9
a
b
Star washer/nut
Washer
Tighten using a Phillips screwdriver and open ended spanner
Locate the top plate (A) and place it on top
of the base plate (C) as shown
Turn the assembly over and tighten the five Phillips
screws to secure the nylon sled fence in position
Remove the star washer/nut and washers from the countersink Phillips screws (P) and place safely aside. Insert the screws
through the two countersink holes on either side of the ‘T’ bar and replace the star washer/nut and washer as shown above
C
