UHP-1100 SATELLITE ROUTER BOARD
GENERAL DESCRIPTION AND INSTALLATION GUIDE, v3.2
© UHP Networks Inc. 2015
8
www.uhp.net
Connection of a computer to the router via LAN interface is implemented through the Ethernet switch or hub via a
standard network cable with RJ-45 connectors (not supplied).
1.3
Labeling and sealing
The product is marked with the unique Serial Number, as well as Part Number on the metal shield of the
modulator.
1.4
Description and principles of operation
1.4.1
Overview
Each module of UHP-1100 satellite router board has its own interface to external devices. All the
interfaces are located on the rear panel of the board. The indicators are located on the front panel. LAN
Indicators are integrated into the LAN connector on the back of the board.
1.4.2
Router composition
UHP-1100 router consists of:
1.
High-speed SCPC/MCPC demodulator
2.
Burst demodulator
3.
Universal modulator
4.
Router
5.
Controller
1.4.3
Power connector (DC IN)
UHP-1100 router board is powered with 24 VDC. AC Power supply adaptor is not supplied. The router can be
powered from a DC power source (batteries, DC-DC converter), but the specific power supply mode should be
agreed upon with the Manufacturer. There are two power inputs (parallel connectivity):
1.
DS-210 connector features dimensions 5.5 / 2.1 mm (outer and inner diameters); positive is on the central
contact;
2.
PWL-2с connector with 3.96 mm step on the board.
1.4.4
LAN interface connector
LAN connector is purposed for connecting to Ethernet switch using a straight cable. Bit rate 10 or 100 and duplex
mode are software selectable. Indicators built into the connector mean the following: left one (green) –
connection (Link) and data transmission (Activity), the right one –yellow) – activation of half-duplex mode.
1.4.5
USB CONSOLE
The console port provides local control of the device.
1.4.6
RESET button
Router reset is provided using this button. Also, using special combination of pressings this button allows router
reset to factory settings.
1.4.7
High-speed demodulator IF input (SCPC RX)
SCPC-RX is one of the two signal inputs to receive signals from the satellite (LNB). This input is designed to receive
continuous (SCPC/MCPC) carriers in DVB-S and DVB-S2 formats from the satellite. The input, on the router side,
can be fed with 18 VDC power supply. Whether power source in on or off, the input can withstand external voltage
up to 50 VDC (power supply circuit is provided with a diode). Power supply circuit is protected with a thermal fuse
operating in case of short circuiting. After short circuiting is removed it may be required to disconnect load from Rx
inputs for several seconds so as to allow the fuse to return to its initial state.
