Uhlenbrock Electronik Gantry Crane 1:87, User Manual

Page: 6 / 8

6
Table of individual CVs (Configuration Variables)
CV Description Value Range Factory Default
1 Short Locomotive Address 1-127 3
2 Minimum Speed 1-63 5
3 Start Inertia 1-63 2
4 Brake Inertia 1-63 2
5 Maximum Speed
Must be greater than CV2 1-63 20
6 Maximum Motor Voltage
Must not be changed 1-255 64
7 Software Version
The processor used can be updated - Varies
8 Manufacturer - 85
17
18
Long Locomotive Address
17 = High Byte
18 = Low Byte
1-9999
192-231
0-255
2000
199
208
29 Configuration of both motors in DCC standard
Bit 0=0 Driving direction not swapped
Bit 0=1 Driving direction swapped
Bit 1=0 14 Speed steps
Bit 5=0 Short Address (CV 1)
Bit 5=1 Long Address (CV 17/18)
Value
0 *
1
0 *
0 *
32
0-33 0
49 Decoder Configuration
Bit 0=0 Motorola on
Bit 0=1 Motorola off
Bit 1=0 DCC on
Bit 1=1 DCC off
Bit 6=0 f1 switches A1 and f2 switches A2
Bit 6=1 f1 toggles A1/A2 (switches between A1 and A2)
f1 off: A1 off und A2 on
f1 on: A1 on und A2 off
Bit 7=0 +20V for Function output RL on the base plate socket
Bit 7=1 Extension module provides RL for the base plate socket
Note: If the Motorola data format is switched off in bit 3 and the DCC data format is switched off
in bit 4, the decoder will not receive any more driving instructions and can only be programmed.
Value
0 *
1
0 *
2
0 *
64
0*
128
1-195 0
65 Motorola Programming Offset 0-255 0
67 Maximum Speed for Key 1 (Analog Operation) 0-255 40
68 Maximum Speed for Key 2 (Analog Operation) 0-255 40
69 Maximum Speed for Key 3 (Analog Operation) 0-255 50
70 Maximum Speed for Key 4 (Analog Operation) 0-255 50
71 Starting Inertia for Key 1 (Analog Operation) 0-255 5
72 Starting Inertia for Key 2 (Analog Operation) 0-255 5
73 Starting Inertia for Key 3 (Analog Operation) 0-255 5
74 Starting Inertia for Key 4 (Analog Operation) 0-255 5
75 Braking Inertia for Key 1 (Analog Operation) 0-255 1
76 Braking Inertia for Key 2 (Analog Operation) 0-255 1
77 Braking Inertia for Key 3 (Analog Operation) 0-255 1
78 Braking Inertia for Key 4 (Analog Operation) 0-255 1
79 Maximum Motor Voltage in Analog operation 0-255 180
98 Timed switching of Outputs A1 + A2
0 = both Outputs not timed
1 = only A1 timed switching
2 = only A2 timed switching
3 = A1 and A2 timed switching
0-3 3
99 Maximum ’On’ time in Seconds
for timed outputs as in CV 98
0-255 45
The factory default values are marked with an *.