Instructions for use (rev 251121)
e.ON sinter base
UGIN DENTAIRE
4
C.
INSTRUCTIONS FOR USE
1.
SAFETY INSTRUCTIONS
1.1.
USE
e.ON sinter base is a sintering furnace to Zirconium oxide (ZrO
2
) dental prostheses. This furnace has to be
operated only by dental professionals. e.ON sinter base have to use in the conditions and for the uses
described in this manual.
Any other use that will be made of it is considered inappropriate. In this case, the
manufacturer declines all liability and immediately cancels the equipment warranty.
According to the product’s instructions and functionalities,
it is imperative to read carefully the instructions
for use before furnace installation and use.
Retain the manual for future reference.
1.2.
SAFETY INSTRUCTIONS
Pictograms’ meaning used in these instructions for use:
General warning
Electrical hazard
Burn hazard - Hot surface
Observe following safety instructions:
-
During operation and after use,
the furnace surface, sole, insulating plate, tray for sinterizing
and cover may reach high temperatures: do not touch.
-
Wear suitable gloves for handling prosthetic objects, tray for sinterizing/cover, sole and
insulating plate.
-
The unit must be connected to an
electrical installation in accordance
with the applicable
standard in the country in which it is being used. This installation must provide
protection
against overcurrent, overload and ground faults.
-
This furnace requires its own power line and must be connected to a circuit breaker.
-
Connect it directly to the mains socket
. Do not use multiple sockets.
-
Ensure that the
connection cables
are in perfect condition to prevent short circuits.
-
Before any
technical intervention
, the unit must be switched off (with the breaker) and
disconnected from the mains power supply.
-
Do not spill liquid
on the ventilation openings or inside the furnace.
-
Do not place any object inside the chamber
(only tray for sinterizing/cover, sole and insulating
plate).
-
The furnace must be placed on a
flat surface
, keeping sufficient clearance around the unit to
ensure proper ventilation.
-
Do not block the ventilation openings
to avoid overheating.
