Instructions for use (rev 251121)
e.ON sinter base
UGIN DENTAIRE
20
8.
MAINTENANCE
Before to carry out the maintenance work and/or cleaning:
-
disconnected from the main power supply
(switch OFF and unplug to mains socket),
-
at room temperature: wait the cooling after use
(risk of burns and/or damage).
Observe the following recommendations to ensure the longevity of the device:
-
Do not use abrasive, solvents or flammables products for cleaning (outside and inside).
-
Clean the machine outside with a soft, dry cloth.
-
Remove any traces on the
screen
with a soft cloth and a small amount of special glass cleaner. Cleaning
wipes for optic products can also be used. For avoid screen damage, do not use a sharp object to operate
the touchscreen.
-
In case of dust into the
chamber
: remove it with a vacuum cleaner
–
do not used compressed air.
-
Visual inspection of the sole, insulating plate and the tray/cover
before use.
If necessary, clean with a vacuum cleaner to remove any particles (dust) - do not use compressed air.
If the support is damaged or cracked: do not use and replace-it.
-
Clean regularly the chamber with a vacuum cleaner (no compressed air).
-
The sole can remain at its location for the realization of the following cycles. Regularly, remove it and
clean both elements and the chamber with a vacuum cleaner (no compressed air).
-
Regularly check the
electrical contacts
of the heating elements and tighten.
NOTE: do not use compressed air to cleaning: risk of damage to the accessories and the suspension of particles
of the refractory material.
