UFO Quasar UFOQUA2790-A, User Manual

Page: 8 / 28

INSTALLATION
QUASAR USER GUIDE
8
CONNECTION
-
FOR 0
-
10 V ( CURRENT SOURCE ) OPERATION
There are three connections required – the fiber port, the 0-10V cables and the mains supply
cable. The fiber port should be connected first before the mains supply. Connect and secure the
fiber optic connector into the collar and the front of the unit and secure using the M5 knurled
locking screw. Ensure the fiber optic connector is fully inserted before tightening the locking
screw.
Never run the luminaire with the fiber optic connector out of the collar.
Wire up and connect RJ45 plugs to the RJ45 connectors on the rear of the luminaire using pin
outs as detailed below. The left hand RJ45 connector controls dimming, the right hand
connector controls the decorative wheel motor. Ensure the 0-10V control system is powered up
and supplying a control voltage.
Plug the IEC connector into the IEC socket and then plug the mains connector into a local mains
supply. Switch on power the mains indicator will illuminate and the illuminator is ready for use.
If no light is produced consult the TROUBLESHOOTING section in this manual.
1. WHITE/ORANGE
2. ORANGE
3. WHITE/GREEN
4. GREEN
5. WHITE/BLUE
6. BLUE
7. WHITE/BROWN
8. BROWN
TOP VIEW OF PLUG
RJ45 - CLIP DOWN, PINS UP
RJ45 Pin No. Wire Color Polarity Function
5 Blue/White +VE Positive (10V) 0-10V Current Source Dimming
7 Brown/White -VE Negative (0V) Remote Potentiometer Dimming
RJ45 CONNECTOR A (LEFT HAND) - DIMMING
RJ45 Pin No. Wire Color Polarity Function
1 Orange/White -VE Negative (0V) 0-10V Current Source Twinkle Motor
3 Green/White +VE Positive (10V) 0-10V Current Source Twinkle Motor
5 Blue/White +VE Positive (10V) 0-10V Current Source Color Motor
7 Brown/White -VE Negative (0V) 0-10V Current Source Color Motor
RJ45 CONNECTOR B (RIGHT HAND) - MOTOR CONTROL