UFO Quasar UFOQUA2790-A, User Manual

Page: 6 / 28

INSTALLATION
QUASAR USER GUIDE
6
CONNECTION
-
FOR REMOTE MANUAL OPERATION
This connection method allows the luminaire to be dimmed remotely using a simple passive
potentiometer control.
There are three connections required – the fiber port, the remote dimmer cable and the mains
supply cable. The fiber port should be connected first before the mains supply. Connect and
secure the fiber optic connector into the collar and the front of the unit and secure using the M5
knurled locking screw. Ensure the fiber optic connector is fully inserted before tightening the
locking screw.
Never run the luminaire with the fiber optic connector out of the collar.
Connect the remote dimmer cable (typically CAT5) to the dimmer as shown below. Wire up and
connect the RJ45 plug to the Quasar end of the dimmer cable and plug into connector A the left
hand RJ45 on the rear of the luminaire using pin outs as detailed below. Only the left hand RJ45
connector is used to control dimming in this way.
Plug the IEC connector into the IEC socket and then plug the mains connector into a local mains
supply. Switch on power, the mains indicator will light and the illuminator is ready for use.
If no light is produced consult the TROUBLESHOOTING section in this manual.
1. WHITE/ORANGE
2. ORANGE
3. WHITE/GREEN
4. BLUE
5. WHITE/BLUE
6. GREEN
7. WHITE/BROWN
8. BROWN
BLUE +VE
BLUE/WHITE
+VE
BROWN/WHITE
+VE
T
O
P
V
IE
W
O
F
P
LU
G
RJ45 - CLIP DOWN, PINS UP CVD1 DIMMER & PLATE
RJ45 Pin No. Wire Color Polarity Function
4 Blue +VE Positive 10V Dimming Supply
5 Blue/White +VE Positive (10V) 0-10V Current Source Dimming
7 Brown/White -VE Negative (0V) Remote Potentiometer Dimming
RJ45 CONNECTOR A (LEFT HAND) - DIMMING