INTRODUCTION
IP
-
03 WEATHERPROOF
ENCLOSURE
USER
GUIDE
2
Thank you for purchasing this UFO weatherproof enclosure which is fitted with an LED light
source unit.
To ensure the enclosure is mounted and connected correctly please read this user guide before
installing and operating or performing any maintenance on the enclosure. To ensure that the
light source within the enclosure is set up optimally and gives a long service life, please read the
light source user guide supplied with the enclosure before installing operating or performing
any maintenance on the unit.
Please keep both these guides for future reference.
This user guide is laid out in 3 sections:
Introduction
- information on the enclosure and its light source.
Installation
- details on how to install and power up the enclosure
(supplements the light source guide).
Maintenance
- maintenance log, troubleshooting guide, technical specification.
IMPORTANT
This product must be installed in accordance with the applicable installation code, by a person
familiar with the construction and operation of the product, and the hazards involved. When
used in the USA or Canada, cables connected to this enclosure must be UL listed and not only
suitable for functional purposes but also for the environment/location in which the enclosure is
installed.
Type Y Attachment:
If the external flexible cable or cord of this luminaire or associated
PSU/driver is damaged, it shall be exclusively replaced by the manufacturer or his service agent
or a similar qualified person to avoid a hazard.
Location:
This enclosure must be located out of direct sunlight and away from areas prone to
flooding.
Circulation:
It is imperative that a gap of at least 300mm is left around the unit and it is located
away from any other heat source. This is to allow air to circulate and prevent overheating. The
location must have free ventilation and must not have an ambient temperature higher than
that specified for the unit.
Mounting:
This enclosure should be fixed upright to a vertical surface only, with sufficient gap
at the front to allow the enclosure lid to be opened the full 130° for internal access.
Seal Integrity:
Always close and secure the enclosure door after access.
