Universal Fibre Optics
7
SETTING THE DMX ADDRESS
1. Disconnect the light source from the mains supply.
2. Tilt the light source on its side and remove the screw from the base as shown
below.
3. Slide the access cover down to remove and set the cover and screw aside.
4. Ensure DIP switch 10 (top) is set to OFF as shown below.
5. Set the address required as detailed in the address table, overleaf.
6. Replace access cover and securing screw,
Note: for DMX control operation to work, Dip switch 10 must be in the off position.
Summary of Contents for GEM SLP-3000M
Page 15: ...Universal Fibre Optics 15...
