CONNECTION – GEMINI DMX
There are 3 connections required – the fibre port, the mains supply cable and the
DMX control cable. The fibre port should be connected first. Connect and secure the
fibre optic connector into the collar and secure using the M5 locking screw.
Connect the IEC power cord into the Desk Top PSU and plug the mains plug into the
electrical supply socket. Switch on power the led Indicator will illuminate and the
light source is ready for use. If no light is produced consult the TROUBLESHOOTING
section.
NOTE: THESE LIGHT SOURCES ARE NOT MAINS DIMMABLE
Connect up the DMX control cables to the Mini-XLR sockets on the rear of the
Illuminator. The recommended plug for these sockets is Multicomp SVP556-TA. The
pin out details for the plugs are shown below. Either socket may be used as DMX in
or DMX out.
Universal Fibre Optics
5
NOTE: CONVERTORS ARE AVAILABLE FROM UFO
Mini XLR to RJ45
Mini XLR to normal 3 pin XLR
Summary of Contents for GEM SLP-3000M
Page 15: ...Universal Fibre Optics 15...
