INSTALLATION
7
UFO
LIGHTING
CONNECTION
-
FOR
0-10
V
(
CURRENT
SOURCE
)
OPERATION
-
CONTINUED
Plug the power supply’s output into the Comet’s power supply input and then connect the
mains plug into a local mains supply. The Comet will initialise and display its current status.
Consult the Troubleshooting and Operation sections in this manual if the Comet does not
power up or operate as expected.
0-10V
NOTES
• This is a current source 0-10V control system. The input from the 0-10V controller (source)
supplies a varying control voltage between 0 and 10v to the luminaire to control the dimming
or decorative wheel motors, or both the dimming and the decorative motors
• Always use an approved CAT5 cable
• With no 0-10V input the luminaire will give no light output and the decorative wheel will be
stationary, but may move slightly. If this movement causes a problem, connect a 0-10V
controller set to 0V or set the Comet to manual control.
Summary of Contents for Comet Light Source
Page 23: ...NOTES 23 UFO LIGHTING ...
