UFO Comet Light Source, Product User Manual

Page: 3 / 24

INSTALLATION
3
UFO LIGHTING
CONTROL &
PROGRAM
BUTTONS
DMX
REMOTE
DISPLAY
CONNECTOR
48V DC
INPUT
CONNECTOR
0-10V / 1-10V
DIMMING
0-10V / 1-10V WHEEL
CONTROL
LCD DISPLAY
IMPORTANT
This product must be installed in accordance with the applicable installation code, by a person fa-
miliar with the construction and operation of the product, and the hazards involved.
These light sources are not mains dimmable.
The LED array in this light source is not replaceable. When it reaches end of life the whole unit
must be replaced.
Type Y Attachment: If the external flexible cable or cord of this luminaire or associated PSU/driver
is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar
qualified person to avoid a hazard.
Location: Do not locate this light source closer than 200mm from any flammable surface.
Clearance / Ventilation: It is imperative that a gap of 200mm is left around the unit. This is to
allow air to circulate and prevent overheating. The location must have free ventilation and must
not have an ambient temperature higher than that specified for the luminaire.
Mounting: This luminaire comes with an integral mounting plate for securing the unit to a
vertical or horizontal surface. Refer to the instruction sheet supplied with the plate.
Warning: Never look directly at the luminaire through the fibre port of the light source.
Warning: The luminaire should be positioned so that prolonged staring into the
luminaire at a distance closer than 2.7 metres is not expected.
Warning: NEVER hot plug the DC connector on the rear of the light source as this may cause arc-
ing of the DC current. Do not disconnect or connect power from the Comet light source by
removing or connecting the DC connector whilst the 48V PSU is live.
REAR PLATE DETAIL