UFESA AE4822 sena, Instruction Manual

Page: 26 / 76

This product complies with European Directive 2012/19/EU on electrical and electronic
devices, known as WEEE (Waste Electrical and Electronic Equipment), provides the legal
framework applicable in the European Union for the disposal and reuse of waste electronic
and electrical devices. Do not dispose of this product in the bin, instead going to the electrical
and electronic waste collection centre closest to your home.
The product may contain batteries. Remove them before disposing of the product and
dispose in special containers approved for this purpose.
TROUBLESHOOTING
The appliance will not power on.
•
This may be caused by a flat battery. This can occur if the appliance has been used or stored for an
extended period of time. Connect the vacuum to the charger and allow for a full charging cycle to
complete.
The vacuum stopped suddenly:
•
This will occur if the safety cut-out device has been activated. This device is designed to prevent your
appliance from overheating. Ensure the vacuum is turned off , disconnect all accessories and leave to
cool down for at least half an hour before attempting to operate again. Try to identify the source of the
overheat by checking for blockages in the extension tube motor-drived floor head and accessories.
Empty the dust container and clean or replace the filter.
The suction of the vacuum has reduced:
•
Turn the vacuum off. Disconnect the floor head, extension tube and any accessories. Check for and
remove any blockages from the dustbin filter, air duct, extension tube
floor head and accessories.
Motorised floor head is not rotating:
•
This tends to occur when there are too many fibres wrapped around the brush roll restricting
movement. Consult the maintenance section of this manual for instructions on how to appropriately
clean the brush roll.
The charging indicator light does not flash up:
•
There may be no power reaching the vacuum from the charger.
Ensure that power is being supplied to the mains socket and that the charger is turned on. Ensure the
charging cable is securely connected to the vacuum
•
Ensure the mains socket is switched off before checking the charging cable itself. Do not attempt to
use if the cable is split, frayed or otherwise damaged. Instead, seek a replacement charger.
The application time of the vacuum is less than it used to be:
•
Ensure the battery has completed a full charging cycle. An insufficient charging cycle will result in
reduced application time.
•
There may be reduced energy discharge in the battery. This is normal and gradually occurs in all
batteries over time.
PRODCUT DISPOSAL
26